Ivo Hladík
More ideas from Ivo
Reprap Prusa 3D Printer Enclosure kit - Vortex-RC

We love our Reprap Prusa printer, however there have been many times when the prints have been warped due to uneven cooling or drafts in the room make it hard for the the bed to heat up.

Drilled holes for fan, PSU and electronics

How I built my DIY printer enclosure with tips and ideas how to build yours.

How I built my DIY 3D printer enclosure with tips and ideas how to build yours. Goes through the whole process from measure and design to build and finish.

DIY printer enclosure with tips and ideas how to build yours. Goes through the whole process from measure and design to build and finish.

How I built my DIY 3D printer enclosure with tips and ideas how to build yours. Goes through the whole process from measure and design to build and finish.

How I built my DIY printer enclosure with tips and ideas how to build yours. Goes through the whole process from measure and design to build and finish.

Filabot by Tyler McNaney has invented a desktop machine that makes the raw materials for 3D printing by grinding up waste plastic from bottles, wrappers and even Lego bricks

Tyler McNaney is raising funds for Filabot: Plastic Filament Maker on Kickstarter! Make your own printing filament from recycled bottles and other plastic products. Never run out of printing filament.

ExtrusionBot.jpg

Extruding plastic pelets can save money on printing supplies. HDPE from milk bottles could take this one step further if you can account for the shrinkage.